`scheduler-k3s:node-sysctls:report` renders each scope's resolved set, so a profile's entry carries every globally-set sysctl underneath its own and there is no way to read back the map the profile itself stores. Since `node-sysctls:set --replace --profile` and `node-sysctls:clear --profile` write only that map, a tool converging a profile against a declared map sees permanent drift. The new `--stored` flag reports the map each scope owns, and `--global` and `--profile` narrow the report to a single scope. The default output is unchanged.
`scheduler-k3s:profiles:add` accepted profile names it could not later derive a valid helm release name from, so a profile was created successfully and only failed on commands with no obvious relationship to it: `profiles:remove` could not delete the profile it created, and a single bad name broke every subsequent node sysctls change, including the global scope and unrelated profiles. Names are now refused at add time against the release name they derive rather than against the profile name alone, and the paths that have to cope with a profile stored before this check keep working instead of erroring.
Sysctls the kernel does not namespace, such as `vm.max_map_count`, cannot be set from a pod spec and previously had no answer beyond editing `/etc/sysctl.d` on each host by hand. `scheduler-k3s:node-sysctls:set` now applies them through a privileged daemonset, which reaches nodes joined later and reapplies after a reboot. Sysctls may be scoped to a node profile, with a profile scope inheriting the global values and overriding them on conflict so that every node is covered by exactly one daemonset. Clearing a sysctl stops dokku managing it but does not restore the previous value, which persists until the node reboots.